NORIT-TE 30 Therm GF underfloor heating element

A 30 mm gypsum fibre screed element with a click joint. It is part of the NORIT underfloor heating system: it distributes the load, and the fixed guide holds the NORIT heating pipe in place, in a variable laying pattern.

30 mm
Pipe 12 mm
Click joint
Fire class A1

Not in the JUPITER Shop. Ask us about the options for your project.

What is NORIT-TE 30 Therm GF suitable for?

Laid with a click joint, without screws.
The fixed guide ensures safe and quick installation of the heating pipe.
Extremely high fitting accuracy of the elements.
Wet rooms up to water exposure class W1-I (W0-I and W1-I).
Board material tested and recommended for healthy building (building biology).

System build-up according to Lindner

Installation height from 23 mm. At least 3 mm of NORIT-Filler Universal goes over the elements. After approx. 24 hours the floor is ready for the floor finish. With a suitable heat pump you can also cool.

Technical data

Versions	GF-U and GF-E
Effective size	1200 × 600 mm
Thickness	30 mm
Weight	approx. 24 kg (GF-U) and approx. 27 kg (GF-E) per element
Density	approx. 1,250 kg/m³
Heating pipe	12 mm
Standard centre-to-centre spacing	120 mm
Joint	Click joint, without screws
Fire class	A1, non-combustible (EN 13501-1)
Product standard	EN 14190
Wet rooms	Water exposure class W0-I and W1-I
Packaging	40 elements per pallet (GF-U approx. 975 kg, GF-E approx. 1,100 kg)

Source: Lindner product data sheet NORIT-TE 30 Therm GF (version 1.0, German) and the product page. Pipe diameter as stated by JUPITER Benelux.

Two elements

GF-U · universal

With milled pipe pattern for bends and straight sections

GF-E · supplementary

With straight grooves

Installation

Tools: hand-held circular saw with guide rail for straight cuts, jigsaw for curves and small cut-outs.

1Let the elements acclimatise on site for 2 days and fit edge insulation along all walls: PE foam, stone wool or an alternative, depending on the requirements.
2Lay the elements according to the laying plan and join them with the click joint, without screws.
3Press the NORIT heating pipe (12 mm) into the milled guide.
4Apply NORIT-Filler Universal, at least 3 mm over the elements.
5After approx. 24 hours you can apply the floor finish, according to the installation guidelines and in line with the wishes and requirements of the floor finish supplier.

How many elements do you need?

The ratio between universal (GF-U) and supplementary elements (GF-E) depends on the pipe layout. Send us the floor plan; we will work it out for you.

Ask for advice